The decomposition of H2O2 was measured by monitoring the decrease in absorbance at 240 nm using a microplate reader (Paradigm, Beckman Coulter). Each strain was run in five replicates.

The initial linear portion of the curve was used to calculate the Δ240 nm. A molar extinction coefficient of H2O2 at 240 nm of 43.6 M-1 cm-1 was used to calculated the concentration of H2O2 using the Beer-Lambert law, A = εcl. One unit of catalase was defined as the amount that decomposes 1 μmol of H2O2 per minute per OD600 at 25°C. Analysis of gene expression Bacteria were collected from cultures after 18 h of incubation and mixed with 50% (v/v) RNAlater (Qiagen, Hilden, Germany) and when needed, placed in -20°C, to stabilize the RNA until extraction could be performed. RNA was extracted

using Trizol Selleck PCI-34051 (Invitrogen) according to the manufacturer’s protocol. cDNA was synthesized from this RNA and quantitative buy Sapanisertib real-time PCR (RT-PCR) was used to analyze the cDNA samples. In order to remove contaminating DNA, the RNA samples were DNase-treated (DNA-free kit, Ambion, Inc, Austin, TX, USA) in accordance with the protocol supplied by the manufacturer. The RNA was quantified by Nanodrop (Thermo Fisher Scientific, Wilmington, DE, USA). cDNA was synthesized from 1 μg of the extracted selleck products RNA using iScript cDNA synthesis kit (Bio-Rad, Hemel, Hampstead, UK) according to the protocol provided by the manufacturer. To control for contaminating DNA in the RNA preparation, a control was prepared by substituting the enzyme from the cDNA synthesis for nuclease-free H2O (Ambion) (control 1). In order to degrade any remaining RNA, the cDNA

was treated with 2.0 μl of 2.5 M NaOH at 42°C for 10 minutes after which the pH was adjusted by the addition of 5 μl of 1 M HCl. The samples check details were thereafter diluted and stored at -20°C. RT-PCR was performed in the ABI Prism 7900HT Sequence Detection System (Applied Biosystems, Foster City, CA, USA) using the Power SYBR green PCR Master Mix (Applied Biosystems) as recommended by the manufacturer. Each reaction contained 12.5 μl of the SYBR green mix, 400 nM of forward and reverse primers, 5 μl of a cDNA and the total volume was adjusted with nuclease free water to 25 μl. Forward and reverse primers were obtained from Invitrogen and their sequences have been previously published [20, 23] with the exception of the pairs used to measure mglA, feoB and katG. The sequences for mglA were the following: FTT1275-F, 5′-TTG CAG TGT ATA GGC TTA GTG TGA-3′ and FTT1275-R, 5′-ATA TTC TTG CAT TAG CTC GCT GT-3′, for feoB: FTT0249-F, 5′-TCA CAA GAA ATC ACA GCT AGT CAA-3′ and FTT0249-R, 5′-CTA CAA TTT CAG CGA CAG CAT TAT-3′ and for katG the following: FTT0721c-F, 5′-TTC AAG TTT AGC TGG TTC ATT CAT-3′and FTT0721c-R, 5′-GCT TGG GAT TCA GCT TCT ACT TAT-3′. The reactions were performed in MicroAmp 96-well plates (Applied Biosystems).