Because fibrous nanostructures have more effective surface area t

Because fibrous nanostructures have more effective surface area than smooth surface, ZnO fibrous nanostructure is expected to be used in photovoltaic devices. Figure 2 Scanning electron microscopy of the ZnO fibrous nanostructure films on the ITO glass. 0.2 (a), 0.4 (b), 0.6 (c), 0.8 (d), and 1.0 M (e) precursor. UV-selleck screening library visible absorption spectra A-769662 order For the ZnO fibrous nanostructure films, the UV-visible absorbance spectra are shown in Figure 3. As the concentration of precursor

increased, the UV-visible absorbance intensity was rapidly increased in the wavelength range of approximately 380 nm in the ultraviolet region and generally increased around all area including the visible region. Therefore, the absorbance was dependent on the concentration of the precursor. Furthermore, ZnO fibrous nanostructure films can protect light oxidation of the device by the ultraviolet area. Figure 3 UV–vis absorption spectra of the ZnO fibrous nanostructure films with increasing concentration of precursor. Performance characteristics The current density-voltage (J-V) curves of the polymer solar cells are shown in Figure 4, and the data selleck chemical are summarized in Table 1. Polymer photovoltaic cells with the structure of ITO/ZnO fibrous nanostructure film (0.2, 0.4, 0.6, and 0.8 M precursor)/PEDOT:PSS/P3HT:ICBA (1:1 wt.%, 20 mg/ml)/Al

were fabricated. Organic solar cell generates photocurrent by photovoltaic effect while passing the sunlight through the cell. Olopatadine That is why, using the current–voltage characteristics in the fourth quadrant at illumination in AM 1.5 conditions, we measured the typical parameters of the cells in the regime of photoelement, such as short-circuit current, open-circuit voltage, fill factor (FF), and power conversion efficiency. The pristine cell has obtained a J sc of 8.9757 mA/cm2 and PCE of 4.55%.

The device including ZnO fibrous film (0.6 M precursor) has a J sc of 12.55 mA/cm2, and the overall PCE of 6.02% was achieved. Furthermore, V oc was improved from 0.8286 to 0.8360 V, and PCE improved from 4.55% to 6.02%. This achievement is attributed to the advancement in the current flow and morphology result of ZnO application on the ITO. It is considered that the wide energy bandgap of ZnO may increase the mobility of holes and result in a wide effective surface area of ZnO nanofiber structures. The hole-transporting ability was improved as the applied ZnO fiber film has 3.36 eV of bandgap between the anode (ITO) and active layer (P3HT:ICBA), therefore resulting in increased J sc. However, FF of the devices decreases from 0.6124 to 0.5976 when applying the ZnO film. As the ZnO film prepared from 0.8 M Zn2+ precursor solution was applied to the device, there were decreases in all electrical characteristics (V oc, J sc, FF, and PCE).

Comments are closed.