46, n-hexane-EtOAc, 7:3). Fraction D crystallized in methanol to give sitosterol 3-O-β-D-glucopyranoside (4) (160 mg; Rf=0.70, CH2Cl2-MeOH, 9:1). Fraction E

() was submitted to silica gel ABT-199 column chromatography and eluted with CH2Cl2:MeOH (19:1, 17:3, 4:1, 7:3, each ) followed by purification through Sephadex LH-20 gel column chromatography Inhibitors,research,lifescience,medical using CH2Cl2:MeOH (1:1) to yield lespedin (3) (21 mg, Rf=0.35, CH2Cl2-MeOH, 9:1). Identification of isolated compounds The structural identification of compounds 1-4 was established using spectroscopic analysis, especially, NMR spectra in conjunction with 2D experiments and direct comparison with published information,6,11,14,15 and authentic specimens obtained in our laboratory for some cases. Melting points of isolated compounds were Inhibitors,research,lifescience,medical uncorrected and determined on a Büchi SMP-20 melting point apparatus and with a Reichert microscope. Infra-red spectra were measured on a Shimadzu FTIR-8400S spectrophotometer and the UV spectra were recorded with a Shimadzu UV-3101 PC, spectrophotometer. Electron impact-mass spectrometry (ionization voltage

70 eV) and High resolution-electron impact-mass spectrometry spectra were measured with a Finnigan MAT double focusing spectrometer Model 8230.1 H-NMR (500 MHz) and,5 C-NMR (125 MHz) spectra were recorded in CDCl3 using a Bruker-Avance-500 Inhibitors,research,lifescience,medical MHz NMR spectrometer and Trimethylsilyl as internal standard. The mixture of sterols was only identified by gas chromatography-mass spectrometry. Gas chromatography-mass spectrometry (GC-MS) data were obtained with an Agilent 6890N Network GC system/5975 Inert X L Mass Selective Detector at 70 eV and 20°C. The GC column was a CP- Sil 8 CB LB, fused silica capillary column ( × , film Inhibitors,research,lifescience,medical thickness 0.25 µm). The initial temperature was 50°C for 1 min, and then heated at 10°C/min to 300°C. For the carrier gas, helium was used with a flow rate of 1.20 ml/min. Kovat’s retention index (KI) was determined using a calibration curve of n-alkanes. Inhibitors,research,lifescience,medical Antimicrobial Assays Determination of Diameters of Inhibition Zones The diameters of inhibition zones were

determined by disc diffusion method as described by Tamokou and co-workers,10 with some modifications. Stock solutions of test samples Resminostat were prepared in 10% v/v aqueous dimethylsulfoxide (DMSO) solution (Fisher chemicals) at concentrations of 100 mg/ml (for crude extract and fractions) and 10 mg/ml (for pure compounds). The inocula of microorganisms were prepared from 24 h old broth cultures. The absorbance was read at 600 nm and adjusted with sterile physiological solution to match that of a 0.5 McFarland standard solution. From the prepared microbial solutions, other dilutions with sterile physiological solution were prepared to give a final concentration of 106 colony-forming units (CFU) per milliliter for bacteria and 2×105 spores per milliliter for yeasts.